Rack-Mounting A Media Gateway Or Media Gateway Expander - Nortel 1000 Installation And Commissioning Manual

Page 84 of 466 Rack-mounting the components
Rack-mounting a Media Gateway or
Media Gateway Expander
NN43041-310 Standard 01.11
References to the Media Gateway in this section also apply to the Media
Gateway Expander. The Media Gateway Expander can be mounted either
above or below the Media Gateway.
The following items are required to mount each Media Gateway or Media
Gateway Expander in a 19-inch rack:
• equipment layout plan
• 8 – #10-32 machine screws
• 19-Inch Rack Mount Kit (NTTK09)
The 19 Inch Rack Mount Kit (NTTK09) contains the following accessories:
• 1 – left guide bracket
• 1 – right guide bracket
• 1 – left ear bracket
• 1 – right ear bracket
• 4 – #8-32 machine screws
Follow Procedure 1 on
a Media Gateway Expander.
Procedure 1
Removing the cover
1 If the cover lock latches are in their locked position:
a. Use a flat screwdriver to slide the icon away from the latch. Refer to
Figure 15 on
b. Slide both spring-loaded latches simultaneously down toward the
bottom of the Media Gateway, and pull forward. Then lift the cover
October 2008
page 84 to remove the cover on a Media Gateway or
page 85.