Status Request Command Codes/Status Information Codes - Denon DN-700R Serial Command Protocol Manual

Status Request Command Codes/Status Information Codes

Use the status request command codes below to check on the status of your DN-700R. In response,
DN-700R will send a corresponding status information code.
In cases where the status request command code includes a variable, the variable is indicated in
italicized font and the potential values are indicated in bold font.
Status Request Commands
(Host → DN-700R)
REQUEST
Admin Login @0?LIxxxx\r
Power Status @0?PW\r
Power On Mode @0?PO\r
@0?MM\r
Source Status
Media Status @0?CD\r
Status Information
(DN-700R → Host)
CODE ANSWER
Success
Failed
On
Standby
Network
Standby
Resume
playback
Play first track
Stop
Record
Selected media
source
Card in
No card
Card error
Unformatted
Write-protected @0CDWP\r
SD door open
CODE
The entered password was correct,
where xxxx stands for the password;
@0LIOK\r
you are now logged in and able to
execute serial commands
The entered password was incorrect,
where xxxx stands for the password;
@0LING\r
you will need to try logging in again in
order to execute serial commands
@0PW00\r The power is on
@0PW01\r DN-700R is in standby
@0PW02\r DN-700R is in network standby
DN-700R is set to resume playback of
@0PORM\r
the last played track when powered on
DN-700R is set to play the first track in
@0POPF\r
the last used folder when powered on
DN-700R is set to stop playback when
@0POST\r
powered on
DN-700R is set to begin recording to the
@0PORE\r last selected media source when
powered on
The currently selected media source,
where XX (the selected media source) =
@0MMXX\r
US (USB), S1 (SD Card 1), S2 (SD Card
2), or NE (the network)
There is an SD card in one of the SD
@0CDCI\r
slots
@0CDNC\r There is no SD card
@0CDCE\r There is an error with the SD card
The currently selected media source is
@0CDUF\r
unformatted
The currently selected media source is
write-protected
@0CDDO\r The SD slot door is open
DESCRIPTION
25