Denon DN-700R Serial Command Protocol Manual page 15

CATEGORY
Next Track
Hot Start Cue Up
Select Track Number (3
digit)
Select Track Number (4
digit)
Select Folder Number
Set File Order
Track Selection
Load Program List
Add to Program List
Take Off Program List
Save Program List
Rewind (cyclic)
Track Searching
Rewind (specific)
Skip Back
Control Commands
(Host → DN-700R)
CONTENTS
@02332\r
@0HCnn\r
@0TRnnn\r
@0Trnnnn\r
@0Sfnnnn\r
@0FRXX\r
@0PlXXXX\r
@0PinnNNNN\r
@0Pmnn\r
@0PsXXXX\r
@02350\r
@02350n\r
@023SB\r
CODE
Skips to the next track in the tracklist
Cues up the track assigned the entered hot start
number, where nn (the hot start number) = 01–
20
Selects the track corresponding to the entered
file number, where nnn (the track file number) =
001–999
Selects the track corresponding to the entered
file number, where nnnn (the track file number) =
0001–2000
Selects the folder corresponding to the entered
number, where nnnn (the folder number) = 0001–
2000
Sets whether files in media source folders are
ordered alphabetically or by date, where XX (the
setting) = AL (alphabetically) or DA (date)
Loads the program list, where XXXX stands for
the program list's file name (absolute path
required)
See Appendix > Entering the Absolute Path
for Folder and File Names
requirements for entering absolute paths
Adds the track to the currently loaded program
list, where nn (the desired position in the
program list) = 01–99, and NNNN (the track file
number) = 0001–2000
Removes a track from its position in the
currently loaded program list, where nn (the
position in the program list) = 01–99
Save the currently loaded program list as a new
file, where XXXX stands for a file name of up to
252 characters (absolute path required)
See Appendix > Acceptable Characters for
Serial Communication
characters can be used in the name of the
program list file
See Appendix > Entering the Absolute Path
for Folder and File Names
requirements for entering absolute paths
Rewinds the current track; each entry of the
command cycles through the rewind speeds (2x,
10x, 50x, 100x, and 200x)
Rewinds the current track at a specific speed,
where n (the speed) = 1 (for 2x), 2 (for 10x), 3 (for
50x), 4 (for 100x), or 5 (for 200x)
Rewinds the current track by a set number of
seconds
DESCRIPTION
for details on the
for details on which
for details on the
15