Control Command Codes - Denon DN-700R Serial Command Protocol Manual

Control Command Codes

Use the codes below to control your DN-700R.
In cases where the control command code includes a variable, the variable is indicated in italicized font
and the potential values are indicated in bold font.
CATEGORY
Power On
Power Standby
Set Power On Mode
Power/Media
Select Media Source
Select Recording Input
Set Recording Channels @0CHXX\r
Initiate Recording
Recording
One Touch Rec On/Off
Pause Recording
Split Recording
Rec Monitor On/Off
Set Input Volume Type
Both Channel Volume
Up/Down
Control Commands
(Host → DN-700R)
CONTENTS
@023PW\r
@02312\r
@0POXX\r
@0MMXX\r
@0INXX\r
@02355\r
@0ORNN\r
@023Rp\r
@023MT\r
@023RMNN\r
@0VIXX\r
@023VX\r
CODE
Powers on DN-700R
Puts DN-700R in standby
Changes the default mode that DN-700R will
enter when it is powered on, where XX (the
mode) = RM (resume playback of the last played
track), PF (play the first track in the last used
folder), ST (stop playback), or RE (begin
recording to the last selected media source)
Selects the media source, where XX (the media
source) = S1 (SD Card 1), S2 (SD Card 2), US
(USB drive), or NE (Network)
Selects the input to be used as the recording
audio source, where XX (the input) = UB (the
RCA input), BA (the analog XLR input), DI (the
coaxial input), or DB (the AES/EBU input)
Sets whether recorded files will be set to stereo
or mono, where XX (the setting) = ST (stereo),
ML (left channel mono), or MX (mixed left and
right channel mono at –3 dB)
If One Touch Recording is set to off, the first
entry of this command puts DN-700R in
recording mode, and the second entry initiates
recording
If One Touch Recording is set to on, the first
entry of this command initiates recording
Turns One Touch Recording on or off, where NN
= 00 (on) or 01 (off)
Pauses an in-progress recording
Splits an in-progress recording into two separate
files at the point the command is executed
Turns the recording monitor feature on or off,
where NN = 00 (on) or 01 (off)
Determines whether the recording input volume
can be adjusted or whether it is fixed at 0 dB,
where XX = VA (can be adjusted) or FX (fixed at
0 dB)
Turns the volume of the recording up or down
1.0 dB for both the left and right channels, where
X (the direction) = + (up) or - (down)
DESCRIPTION
7