Table of Contents
Advertisement
ANT130LZS Hardware Manual
Chapter 2: Mechanical Specifications and Installation
W A R N I N G : ANT130LZS installation must be in accordance to instructions provided by this
manual and any accompanying documentation. Failure to follow these instructions could result
in injury or damage to the equipment.
2.1. Unpacking and Handling the Stage
W A R N I N G : It is the customer's responsibility to safely and carefully lift the stage.
Make sure that all moving parts are secure before moving the ANT130LZS. Unsecured
l
moving parts may shift and cause bodily injury.
Improper handling could adversely affect the performance of the ANT130LZS. Use care
l
when moving the ANT130LZS.
N O T E : If any damage has occurred during shipping, report it immediately.
Carefully remove the ANT130LZS from its protective shipping container. Gently set the ANT130LZS on a
smooth, flat, and clean surface.
Before operating the ANT130LZS, it is important to let it stabilize at room temperature for at least 12 hours.
Allowing it to stabilize to room temperature will ensure that all of the alignments, preloads, and tolerances are
the same as they were when tested at Aerotech. Use compressed nitrogen or clean, dry, oil-less air to
remove any dust or debris that has collected during shipping.
Each ANT130LZS has a label listing the system part number and serial number. These numbers contain
information necessary for maintaining or updating system hardware and software. Locate this label and
record the information for later reference.
www.aerotech.com
Mechanical Specifications and Installation
Figure 2-1:
Shipping Clamps
Chapter 2
15
Advertisement
Table of Contents
