Mute Mode; Remote Control Settings - Otto Bock Genium X3 Series Patient Information

Prosthesis Status Inquiry
1� Selecting and confirming "Status" displays the following:
• The total pedometer value ("Step")
• The daily pedometer value ("Trip")
• The battery capacity of the prosthesis in percent ("Batt�")
• The estimated remaining operating time of the prosthesis in hours during active use and at rest
(e�g� sitting function) („Stb/Act" for Standby/Active)
• The next service due date
2� Selecting "Trip" and pressing the selection key resets the day step counter�

Mute Mode

The remote control ca be used to send the knee joint into a mute mode, in which all vibration and
beep signals are disabled� All other functions of the knee joint are unaffected�
The mute mode can be disabled with the remote control or by attaching the charger�
Proceed as follows to activate the Mute mode:
1� Select "Status" in the main menu and press enter to confirm�
2� Navigate to the entry "Mute" and press enter to confirm�
To deactivate the mute mode repeat this procedure, or connect the Charger�
CAUTION
Feedback is disabled. When the mute mode is active, all vibration an beep signals are disabled�
In case of mode change, low battery or system errors, the mode will be changed (or safety
modes will be activated, respectively) without warnings� If unexpected, this can cause you to fall�
Be aware of this fact before activating the mute mode�

Remote control Settings

1� Select "RC Settings" in the main menu and confirm using the enter button�
2� Adjust the date and time by selecting the corresponding line� Change settings using the navi-
gation keys�
3� Additional connections can be set up ("Pairing") and connections can be deleted ("Delete con-
nection") (see the section Prosthesis Administration)�
Genium X3 - Bionic Prosthetic System Ottobock | 19