Status Bar; Changing Prosthesis Settings - Otto Bock Genium X3 Series Patient Information

Status Bar

The status bar shows:
1� Battery capacity of the remote control
2� Charging state of the knee joint with percentage indicator
3� Current MyMode
4� In case of a deviation from normal knee joint functionality (e�g�
when the charger is connected), an exclamation mark is shown
in the status bar at the top right� The current MyMode is not
displayed in some of these situations�
MyMode Switching via remote control
Once an active connection to the prosthesis has been established, the remote control can be used
to switch between MyModes�
1� Select "Mode" in the main menu and confirm with the enter button�
2� A list of the available MyModes is displayed� Use to select the desired MyMode and confirm
with the enter button� If the list of MyModes was called up accidentally, the active MyMode can
be selected again�
3� The remote control can be turned off by selecting and confirming "RC Power off"�

Changing Prosthesis Settings

Once an active connection to the prosthesis has been established, the settings of the respective
MyMode can be changed using the remote control�
1� Select "Device settings" from the main menu and confirm with the enter button�
2� A list of available parameters for the current MyMode is displayed� Select the desired parameter
and confirm with the enter button�
3� A screen with a scale, the current parameter value and the limit values is displayed� Press
to change the setting as required and confirm with the enter button�
4� The list of parameters can be closed without making changes by selecting and confirming the
arrow symbol� To select the arrow symbol, use the enter button �
16 | Ottobock Genium X3 - Bionic Prosthetic System