Mounting The Front Panel - Hanseatic 697144 User Manual

Page EN-26 Installation, substructure, connection and initial use
(26)
8. To position the dishwasher so that it is
level, the two front feet (26) and the back
foot on the appliance can be adjusted by
up to 50 mm.
– The front feet are equipped with slots.
Insert a screwdriver into one of the slots
and turn the feet to the height required.
– You can adjust the height of the back
foot with the centre adjusting screw.
Use a Phillips-tip screwdriver for this.
9. Check the alignment with a spirit level.
10. Make sure the top edge of the dishwash-
er is level with the bottom edge of the
worktop to prevent it from tipping forward
when you open the dishwasher door.
11. Screw the dishwasher to the kitchen

Mounting the front panel

You can mount a front panel on the dishwash-
er which matches your kitchen. The front pan-
el must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
2. Measure the distance between the front
3. A gap of 5 mm to 25 mm can be offset
4. If you only need one moulding, saw
(e)
(j)
(f) (i)
unit.
a) If you have granite worktops, re-
move the internal side cover caps (f)
and screw the dishwasher to the ad-
jacent kitchen cupboards.
Re-cover the screws (i) with the cover
caps.
b) For all other worktops, screw the
mounting bracket (e) to the work sur-
face until it is fixed.
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
panel and the control panel.
(g)
with the 5 mouldings supplied (g). Re-
move the required number of moulding
from the block. To do so, move the mould-
ing vigorously but without using tools.
off the four feet that stick out,
clamp the moulding under
the control panel and secure
it using both countersunk
screws (l).
Continue with Step 7.