Test Run - Hanseatic 697144 User Manual

The display (8) shows the current hard-
H1 H6
ness level ( bis ),
4. Press the start/pause button
many times as necessary to display the
required hardness level.
5. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.

Test run

You must carry out a test run once before
the first dishwasher cycle in order to remove
production residues and excess dishwasher
salt and to ensure that the device is in perfect
working order. Carry out this test run when
the dishwasher is empty and without any
dishwasher detergent.
1. Open the valve completely.
2. Close the dishwasher door.
3. Switch it on using the button (1).
All the lights initially come on on the
display (8). After a short time, the pro-
gramme symbol (10) for the ECO pro-
gramme comes on.
Installation, substructure, connection and initial use
(6) as
4. Start the programme with the button
(6).
The programme begins after a few sec-
onds.
5. Check for water leaks and unusual nois-
es.
6. When the programme ends, an acoustic
signal sounds 8 times.
Switch the dishwasher off using the but-
ton (1).
7. Slightly open the door to allow the moist
air to escape.
8. Close the valve.
If no water has escaped and no unusual nois-
es have been heard, the dishwasher is ready
for operation and you can now load it with
dishes.
WARNING!
Risk of poisoning!
Dishwasher detergents, rinse aid and
dishwasher salt can be damaging to
the health.
Keep these products out of the reach
■
of children and pets.
Do not drink the water in the washing
■
compartment.
Page EN-29