Hanseatic 697144 User Manual page 63

5. If you need more than one moulding,
turn the lower moulding and push it onto
the other mouldings. This hides the feet
and makes the surfaces flat.
6. If you
– need two mouldings, secure these using
both countersunk screws (l).
– need three mouldings, secure these us-
ing both countersunk screws (m).
– need four to five mouldings, secure these
using both countersunk screws (n).
(h)
7. Pull apart the two pairs of velcro
straps (h).
8. Remove the protective film from the
same type of velcro strap.
9. With the protective film removed, stick the
Velcro strips (h) to the middle of the re-
cessed areas on the dishwasher door.
10. Cut the positions of the Velcro straps out
of the drilling template.
11. Cut the number of mouldings used off the
drilling template.
Installation, substructure, connection and initial use
(h)
(h)
12. Lay the supplied drilling template on the
reverse side of the front panel in such
a way that the drilling template and the
front panel are flush at the top.
13. Transfer the drill holes from the drill tem-
plate to the front panel.
14. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
15. Remove the protective films from the
other velcro straps and stick the velcro
straps to the front panel using the drilling
template.
16. Fix the front panel to the dishwasher
door using the Velcro strips (h), hold it
firmly and carefully open the door.
Page EN-27
(h)
(h)