Error Messages On The Display - Hanseatic 697144 User Manual

Problem Possible cause
The dishwasher salt is
The display
clumpy.
(13) is illuminated
although dishwash-
er salt has been
added.
The water is not There is a kink in the inlet
running or it is hose.
running only very
The water tap is not proper-
slowly.
ly on.
The water is not The filters are blocked.
running off or only
The outlet hose is kinked,
very slowly.
has been extended or is
hanging too high up/too low.
The dishwasher is The door seal is defective.
not watertight.
The outlet hose or the inlet
hose is defective.
The dishwasher The dishwasher can only be
can be switched operated when the door is
on/off, but not can- closed.
not be operated.

Error messages on the display

Code Solution
E1
: It takes too long Turn the water tap on completely.
for the water to fill
Lay out the inlet hose in such a manner that it is not kinked. See „Connect-
up.
ing the inlet hose".
Ensure that the water pressure is correct. See „Setting the water hardness"
on page EN-28.
E4
: Water overflow Switch off the tap. Find the gap in the seal (or have someone find it) and
repair the leak (or have it repaired).
Troubleshooting table
Solution
Stir the dishwasher salt using the end of a
spoon or similar.
Lay out the inlet hose in such a manner
that it is not kinked.
Turn the water tap on completely.
Clean the filters (see page EN-21).
Lay out the outlet hose in the proper man-
ner (see page EN-23).
Have the door seals replaced (see „Ser-
vice" on page EN-33).
Have the defective hose replaced (see
„Service" on page EN-33).
Close the door.
Page EN-31