Table of Contents
Advertisement
1-1. INTRODUCTION.
This publication describes the Power Drive Intermedi-
ate (PDI) lift truck manufactured by Big Joe Manufac-
turing Company, Des Plaines, Illinois, 60018. Included
are operating instructions, planned maintenance
instructions, lubrication procedures, corrective mainte-
nance procedures and a complete parts list with parts
location illustrations.
Users shall comply with all requirements indicated in
applicable OSHA standards and current edition of
A.N.S.I. B56.1 Part II. By following these requirements
and the recommendations contained in this manual,
you will receive many years of dependable service
from your Big Joe lift truck.
The lift truck is identified by a model number. The
model number shows truck capacity and load center. A
typical model number is explained below.
PDI0404
https://forklift-manuals.jimdofree.com
SECTION 1
DESCRIPTION
R6209
The model number will be found on the
along with the serial number, lifting capacity, and load
center.
Figure 1-3
main components and controls.
location and identification of the decals. Also listed is
the touchup paint used on both the older and new
model PDI trucks as well as the location of the trucks
serial number and name plate.
1-2. GENERAL DESCRIPTION.
The self-propelled PDI truck,
transports payloads up to 2000 pounds on either rigid
or adjustable forks.
The forward and reverse motion is controlled by the
speed controller switch in the control head. Stopping
and turning is controlled by the steering arm. Lift and
Lower is controlled by either a lever mounted on the
chassis, optional pushbutton controls located on the
steering arm, or a control box attached by a coiled
cord.
Figure 1-1 Name Plate
shows the locations of the trucks
Figure 1-2
Figure
(Figure
1-1)
shows the
1-3, lifts and
1-1
Advertisement
Table of Contents
Troubleshooting
