Table of Contents
Advertisement
R1752
8-4. LIFT CHAIN REPLACEMENT.
8-4.1. Telescopic and Non-Telescopic.
1.
Place a solid block on floor under the vertical
members nearest the center of the lift carriage.
2.
Lower carriage until it is supported by the block
and the load chains are slack, then disconnect
battery.
WARNING: Before attempting any actual replace-
ment, make certain power is discon-
nected.
3.
Remove cotter pin (16,
17,
Figure
8-3) and clevis pin (14,
ure 8-2
or 16,
Figure
nected to mast cross brace.
PDI0404
https://forklift-manuals.jimdofree.com
Figure 8-3 Elevation System (Non-Telescopic)
Figure
8-1,
Figure 8-2
Figure
8-1,
Fig-
8-3) from end of chain con-
4.
Remove cotter pin (16,
17,
Figure
8-3) and clevis pin (14,
ure 8-2
or 16,
bolt (17,
Figure
5.
Remove chain from ram head assembly (25,
ure
8-1,
Figure 8-2
for repair.
6.
Position new chain in place on ram head assem-
bly.
7.
Install cotter pin and clevis pin on chain adjusting
bolt.
8.
Connect end of chain to mast cross brace with
or
cotter pin and clevis pin.
9.
Adjust chain according to paragraph
Figure
8-1,
Figure 8-2
Figure
Figure
8-3) from chain adjusting
8-1,
Figure 8-2
or 18,
Figure
or 5,
Figure
8-3) and lay aside
8-2.
or
8-1,
Fig-
8-3).
Fig-
8-3
Advertisement
Table of Contents
Troubleshooting
