Safety Symbols; General Description; Name Plate And Warning Decal - Big Joe CB22 Operator's Manual

WARNING and CAUTION are both signal words intended to alert the viewer to the
existence and relative degree of a hazard. They are both preceded by a safety alert
symbol consisting of an exclamation mark enclosed by a triangle.
A Warning indicates a hazard which could result in injury or death if proper precau-
tions are not taken.
A Caution indicates a reminder of routine safety practices.
A prohibition slash (circle with diagonal slash through it) indicates a procedure or
action that should not be performed under any circumstances, as both personal injury
and/or damage to equipment will result.
Trucks in the Big Joe Counterbalance
series utilize a weighted frame to coun-
terbalance the load. Most models are
equipped with tilt cylinders used to tilt
the mast back during transport.
Control for steering, braking, forward
and reverse travel, horn and speed con-
trol are all located on the control handle.
Name plate and warning decal loca-
tions may vary between models, but
they are always near the steering arm
within sight of the operator.
If the name plate or warning deal are lost
or damaged they should be replaced
immediately. Have your supervisor or
the designated authority contact Big
Joe Authorized Dealer for replacement.

SAFETY SYMBOLS

GENERAL DESCRIPTION

NAME PLATE AND WARNING DECAL

All trucks feature an automatic high
speed cut-off circuit which locks out
high speed when the forks are elevated.
Trucks in this series may vary in load
capacity, battery arrangement, instru-
mentation and lift/lower controls,
depending on model and options.
The name plate shows the model num-
ber, serial number, truck type, battery
type, voltage, minimum weight, and
maximum lift height. It also contains
information on the load capacity and
load center. The warning decal contains
warnings which also appear, with illus-
trations, in the Operation section of this
manual.
2