Load Wheels - Big Joe PDI Series Operation Maintenance Manual & Parts List

7-6. LOAD WHEELS.

NOTE: Refer to Figure 7-3
dure.
1. Block the caster wheels and remaining load wheel
securely, and set the brakes.
2. Raise front end of lift truck with a jack or another
lift truck. Place strong supports under straddle leg
immediately in back of wheel housing so that the
load wheel being replaced is held approximately
one inch from the floor.
3. Remove the two snap rings (1,
ing the load wheel axle (3).
4. Remove roll pin (8), then remove axle. Load
wheel (4) will drop free, along with two spacers
(2), one on each side, which position wheel on
axle.
5. Remove bearing (5) and two retaining washers
(6).
6. Clean and check bearing for defects. Replace
bearing if defective.
7. Lubricate bearing.
8. Reinstall bearing (5) with two retaining washers
(6) and two spacers (2) into load wheel (4).
9. Position load wheel (4) in straddle leg with axle
holes aligned.
10. Install axle (3) through straddle leg and load
wheel.
11. Install roll pin (8) through roll pin hole in axle.
12. Install snap rings (1) on both end of axle.
13. Lubricate axle through grease fitting (7).
14. Remove supports from under straddle leg, lower
front end of lift truck, remove wheel blocks, and
release brakes.
7-4
https://forklift-manuals.jimdofree.com
for the following proce-
Figure 7-3) secur-
LOAD WHEEL AND AXLE KIT
PART NUMBER 901326
CONTAINS:
ITEM
1
2
3
7
8
R1756
Figure 7-3 Load Wheels
QTY
2
2
2
1
1
PDI0404