Big Joe PDI Series Operation Maintenance Manual & Parts List page 48

16. Connect the new cable connector (9) to the con-
nector on the contactor panel.
17. Route and connect cable wire numbers 3 and 8 to
the dead man switch.
18. Route and connect cable wire number 7 to the
horn switch.
19. Wipe off excess grease or silicone spray from
exposed parts of the cable.
20. Route connector (8) end of cable under spring
tube assembly (3) and out the opening at the
elbow.
21. Eliminate cable slack in pivot tube (10); then
secure cable with cable clamp (1).
CAUTION: Improper cable loop adjustment while
performing the following step will dam-
age the cable. If too tight, the cable will
tear when the steering arm is in the up
position. If too loose, the cable will
buckle or be pinched when the steering
arm is in the down position.
5-12
https://forklift-manuals.jimdofree.com
22. Loop cable around spring tube assembly (3) as
illustrated and push connector (8) end of cable
through steering arm.
23. Secure cable with cable clamp (2).
NOTE: Although a new connector (8) is supplied with
the new cable, it is not attached. The new
connector (8) must be attached to the wire
connector pins of the new cable. Each wire is
numbered and must be connected to its cor-
responding pin receptacle number in the con-
nector.
24. Plug the wire pins into their corresponding recep-
tacles in the connector (8).
25. Position the control head close enough to the
steering arm to reach the connector (8).
26. Reconnect the connector (8) to the corresponding
connector in the control head.
27. Secure the control head to the steering arm with
the four screws (7).
28. Reconnect battery.
PDI0404