Safety Symbols; General Description; Name Plate And Warning Decal - Big Joe PDSR Operator's Manual

WARNING and CAUTION are both signal words intended to alert the viewer to
the existence and relative degree of a hazard. They are both preceded by a safety
alert symbol consisting of an exclamation mark enclosed by a triangle.
A Warning indicates a hazard which could result in injury or death if proper pre-
cautions are not taken.
A Caution indicates a reminder of routine safety practices.
A prohibition slash (circle with diagonal slash through it) indicates a procedure or
action that should "NOT" be performed under any circumstances, as both per-
sonal injury and/or damage to equipment will result.
The Big Lift LLC Straddle trucks utilize
the straddle leg configuration, which
normally straddles the load.
Control for steering, braking, forward
and reverse travel, horn and speed
control are all located on the control
handle. All trucks feature an auto-
Warning decal locations may vary
between models, but they are always
near the steering arm within sight of
the operator. The name plate is
mounted on the right side of the truck
frame. See illustration on next page
If the name plate or warning decal are
lost or damaged they should be
replaced immediately.
supervisor or the designated author-

SAFETY SYMBOLS

GENERAL DESCRIPTION

NAME PLATE AND WARNING DECAL

Have
matic high speed cut-off circuit which
locks out high speed when the forks
are elevated.
Trucks in this series may vary in load
capacity, battery arrangement, instru-
mentation
depending on model and options.
ity contact Big Lift LLC Authorized
Dealer for replacement.
The name plate shows the model
number, serial number, and truck
type. Battery type, with voltage and
minimum weight, is shown along with
information on the load capacity and
load center.
your
The warning decal contains warnings
which also appear, with illustrations, in
the Operation section of this manual.
2
and lift/lower controls,