Features - Fujitsu PRIMERGY RX100 S3 Operating Manual

Introduction
1.2

Features

System Board
The features of the system board can be found in the Technical Manual of the
system board D2004 for the hardware and in the "BIOS Setup" for the firmware
(see "Related publications" on page
Hard Disk Drives
The server may have a maximum of two hard disk drives with SATA interface.
There are two server variants:
– Server with non hot-plug hard disk drives (mounted in an "easyChange" hard
disk carrier)
– Server with hot-plug hard disk drives (see
page 57)
The different features of each server variant are described in the appropriate
sections of this manual.
Accessible Drives
An CD or DVD drive is available.
Power Supply
The server has a fixed, wide range power supply unit that adjusts automatically
to a power voltage in the range from 100 V - 127 V or 200 V - 240 V.
High Level of Availability and Reliability
When memory data are accessed, 1-bit errors in the main memory are recog-
nized and automatically corrected with the ECC (Error Correcting Code)
method.
ASR&R (Automatic Server Reconfiguration and Restart) restarts the system in
the case of an error and automatically "hides" the defective system components.
The PDA (Prefailure Detection and Analyzing) technology from Fujitsu Siemens
Computers analyzes and monitors all components important for system
reliability.
U41615-J-Z156-1-76
63).
"Hot-plug Hard Disk Drives" on
Features
7