Fujitsu PRIMERGY RX100 S3 Operating Manual page 33

Hardware Installation
Mounting the rails
To fasten the telescopic rails, no flange nuts are necessary since the rails are
equipped with threaded holes.
Figure 5: Mounting the left telescopic rail
Ê Position the left telescopic rail onto the support bracket by inserting the small
horizontal lead (between the securing holes on the rear end of the rail) in the
corresponding hole.
Ê Press the rail together, and position it onto the frontal support upright, and
release it again.
The rail will be adjust automatically in the rack clearance depth.
Ê Secure the telescopic rail on the frontal left support upright and on the
support bracket, each with two screws M5x10 incl. plugwashers.
Ê Repeat the steps with the right telescopic rail (to be mounted on the right
support uprights).
Ê Mount the server (see
U41615-J-Z156-1-76
Installing/Removing the Server into/from the Rack
section "Installing the Server" on page 35).
33