Fujitsu PRIMERGY RX100 S3 Operating Manual page 43

Preparation for Use/Operation
1 Global Error indicator (amber)
Does not light when the system is ok. No service incident or critical
event has occurred.
Flashes amber when a critical event has occurred. Users can check
BIOS Setup, systemlog and eventlog or via ServerView for event details.
The indicator also flashes in standby mode.
Lights amber when a prefailure event has been recognized. Users
can check systemlog and eventlog or via ServerView for event details.
The indicator also lights in standby mode.
If the event is still acute after a power failure, the indicator is activated
after the restart.
2,3 LAN port s indicators
Each LAN port (1 and 2) is equipped with a green LED indicator (3)
on the left upper side and a amber/green LED indicator (4) on the
right upper side.
These indicators are described in the Technical Manual for the
D2004
system board (see
4 Identification indicator (blue)
Pressing the identification button on the front panel lights up synchro-
nously the integrated identification indicator on the front and on the
rear of the server.
Lights up blue when the system has been selected by pressing the
identification button. To deactivate, press the button again.
The indicator can also be activated via ServerView and its status is
also reported to ServerView.
Table 5: Indicators on the rear
U41615-J-Z156-1-76
Operating and Indicator Elements
"Related publications" on page 63).
43