Necessary Parts; Preparing The Server - Fujitsu PRIMERGY RX100 S3 Operating Manual

Hardware Installation
4.3.2

Necessary Parts

For mounting the server into the appropriate rack the following parts are
available:
– support bracket
– one left and one right telescopic rail (assembled)
4.3.3

Preparing the Server

Ê Open one of the telescopic rails completely.
Ê Push the locking spring and pull the u-shaped telescopic bar completely out
from the rail.
Ê Repeat both steps with the second telescopic rail.
Figure 3: Fastening the telescopic bar to the server
Ê Place the u-shaped telescopic bars with the flat side on the left and/or on the
right on the server.
Ê Fasten the telescopic bars with 3 screws (M4) each, to the server (left and
right).
U41615-J-Z156-1-76
Installing/Removing the Server into/from the Rack
31