Mounting In 3Rd-Party Racks - Fujitsu PRIMERGY RX100 S3 Operating Manual

Installing/Removing the Server into/from the Rack
4.3.5

Mounting in 3rd-Party Racks

For mounting the server in the 3rd-Party Rack the following parts are necessary:
– one left and one right telescopic rail (assembled)
Ê Take the original manual of the rack manufacturer regarding the mechanical
installation and/or the climatic conditions to assistance.
V
CAUTION!
With the installation in 3rd-Party Rack it is to be made certain that the
air flow is ensured from the front to the rear in the rack.
Ê Mount the necessary manufacturer original parts (like support brackets).
I
Sometimes a number of parts of the delivered mounting kit cannot be
used because original parts of the 3rd-Party Rack are to be used.
Ê Mount the telescopic bars as described in
page 31.
Ê Secure the telescopic rails into the rack as described in
the PRIMECENTER/DataCenter Rack" on page
Ê Mount the server (see
the cables as described in the original manual of the rack.
34
section "Installing the Server" on page
Hardware Installation
section "Preparing the Server" on
section "Mounting in
32.
U41615-J-Z156-1-76
35) and route