Fujitsu PRIMERGY RX100 S3 Operating Manual page 17

Important Notes
V
CAUTION!
Data cables must be adequately shielded to avoid interference.
To the LAN wiring the requirements apply in accordance with the
standards EN 50173 and EN 50174-1/2. As minimum requirement
the use of a protected LAN line of category 5 for 10/100 Mbps
Ethernet, and/or of category 5e for Gigabit Ethernet is considered.
The requirements of the specification ISO/IEC 11801 are to be
considered.
Route the cables in such a way that they do not form a potential
hazard and that they cannot be damaged. Refer to the relevant notes
in the operating manual when connecting the device.
No data transmission cable should be connected or disconnected
during a thunderstorm (lightning hazard).
In emergencies (e.g. damaged casing, elements, or cables,
penetration of liquids or foreign matter), switch off the device immedi-
ately, remove the power connector from the grounded power socket,
and contact your customer service centre.
Proper operation of the device (in accordance with IEC 60950/
EN 60950) is only ensured if the casing is completely assembled and
the rear covers for the installation openings have been put in place
(electric shock, cooling, fire protection, interference suppression).
Install only system expansions that satisfy the requirements and rules
governing safety and electromagnetic compatibility and relating to
telecommunications terminal equipment. If you install other expan-
sions, you may damage the system or violate the safety regulations
and regulations governing RFI suppression. Information on which
system expansions are suitable can be obtained from the customer
service centre or your sales outlet.
The components marked with a warning label (e.g. lightning symbol)
may only be opened, removed, or exchanged by authorized, qualified
personnel.
The warranty is invalidated if the device is damaged during the instal-
lation or replacement of system expansions.
You may set only those resolutions and refresh rates specified in the
"Technical data" section of the monitor description. Otherwise, you
may damage your monitor. If you are in any doubt, contact your sales
outlet or customer service centre.
U41615-J-Z156-1-76
Notes on Safety
17