Replace Battery In The Fan/Battery Module - Siemens SIMOTION D4 5 Series Manual

Supplementary system components
6.2 Fan/battery module
6.2.3

Replace battery in the fan/battery module

Overview
The procedure for replacing the fan/battery module's battery is described below. Batteries for
double fan/battery modules are replaced in a similar way and so are not referred to explicitly.
Procedure
Proceed as follows to replace the battery:
1. Press the latch.
2. Tilt the fan/battery module forwards at an angle and pull out the plastic guide from the
3. Remove the battery using a screwdriver (at the side) and disconnect the battery from the
4. Connect the cable connector of the new battery to the mating connector in the fan/battery
Figure 6-3
5. Hold the fan/battery module at an angle to the front with the open side facing up (battery
6. Push the plastic guide into the cutout on the underside of the control unit.
7. Tilt the fan/battery module up until the front latch snaps into place.
78
This detaches the module from its front latch (see figure above).
control unit cutout.
module by unplugging the connector.
module and push the battery in.
Change the battery in the fan/battery module
visible).
The electrical connection between the fan/battery module and the control unit is made
automatically.
SIMOTION D4x5
Manual, 02/2012