Remove The Server From The Rack; Access The Product Rear Panel - HPE ProLiant DL385 Gen10 Maintenance And Service Manual

3. After performing the installation or maintenance procedure, slide the server back into the rack, and then press the
server firmly into the rack to secure it in place.
WARNING: To reduce the risk of personal injury, be careful when pressing the server rail-release latches and
sliding the server into the rack. The sliding rails could pinch your fingers.

Remove the server from the rack

To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or third-party rack, complete the
following.
Procedure
1. Power down the server .
2. Extend the server from the rack.
3. Disconnect the cabling and remove the server from the rack.
For more information, see the documentation that ships with the rack mounting option.
4. Place the server on a sturdy, level surface.

Access the product rear panel

Release the cable management arm
Procedure
Release the cable management arm and then swing the arm away from the rack.
Removal and replacement procedures
37