Cmos Clear (Jcoms1); At/Atx Mode Selection (Pson1); System Memory; Memory Installation - Advantech AIMB-228 User Manual

1.8.2

CMOS Clear (JCOMS1)

Function
Normal (default)
Clear CMOS data
1.8.3

AT/ATX Mode Selection (PSON1)

Function
ATX mode (default)
AT mode
1.9

System Memory

AIMB-228 is equipped with two sockets for 260-pin SODIMM. These sockets are
compatible with 1.2V unbuffered double-data-rate synchronous, low-voltage DRAM
(DDR4 SDRAM). DRAM is available in capacities of 1, 2, 4, 8, and 16 GB. The socket
supports any combination of DIMMs of any size, for a total memory size of 2 to 32
GB. AIMB-228 supports ECC (error checking and correction) memory.
1.10

Memory Installation

To install SODIMMs, first ensure that the handles of the SODIMM socket are in the
"open" position (i.e., the handles lean outward). Slowly slide the SODIMM module
along the plastic guides on both ends of the socket. Then gently press the SODIMM
module into the socket until there is an audible click indicating that the two handles
have locked the memory module into place. To remove the memory module, push
both handles outward, and the memory module will be ejected.
AIMB-228 User Manual
Jumper Setting
1 2 3
1 2 3
Jumper Setting
14