Table of Contents
Advertisement
2) Remove the connector cover [1].
- Screw [2]
[1]
3) Remove the connector [1] and the three screws [2] in the rear side.
[2]
4) Remove the three scerws [1], and then remove the delivery roller 1/2 unit
[2].
[2]
[1]
[2]
F-2-125
[2]
[1]
F-2-126
F-2-127
CAUTION:
When reinstalling the delivery roller 1/2 unit, position it with the pressure
arms [4] on its reverse side in the holes [5] of the spine unit. If it is difficult
to position the delivery roller 1/2 unit, turn the spine drive pulley [6]
manually to move the spine unit.
5) Disconnect the 2 connectors [1], remove the reuse band [2] and free the
harness from the edge saddles and wire saddles, and then take out the
spine bending harness (left) [3].
[1]
[2]
Chapter 2
[4]
[5]
[6]
F-2-128
[1]
[3]
F-2-129
2-29
Advertisement
Table of Contents
