Table of Contents
Advertisement
8) Remove the arm springs [1] and the shaft spring [2] to detach the transport
driven roller 2.
[2]
NOTE:
There is a groove on the roller shaft to slide the slit of the roller shaft mount.
Remove and install the transport driven roller sliding the groove.
2.1.40 Before replacing the transport driven roller 2
(Delivery roller 1/2 unit) (15 million sheets)
1) Remove the rear cover. (page 2-4)Reference[Removing the Rear Cover]
2) Draw out the cover transport assembly. (page 2-5)Reference[Drawing
out the Cover Transport Assembly]
2.1.41 Transport driven roller 2 (Delivery roller 1/2 unit)
(15 million sheets)
1) Open the transport roller 4/5 unit [1].
[1]
F-2-107
[1]
F-2-108
[1]
F-2-109
2) Remove the connector cover [1].
- Screw [2]
3) Remove the connector [1] and the three screws [2] in the rear side.
0024-6871
4) Remove the three scerws [1], and then remove the delivery roller 1/2 unit
[2].
0024-6872
[2]
[1]
[2]
F-2-110
[2]
[2]
[1]
F-2-111
[1]
F-2-112
Chapter 2
2-25
Advertisement
Table of Contents
