Table of Contents
Advertisement
4) Remove the transport roller unit 2/3 [1].
- 4 screws [2]
[2]
CAUTION:
Install the spine bending unit so the locking arm [3] on the back of the
transport roller 2/3 unit will fit into the hole [4] in the spine bending unit. If
you have difficulty precisely locating the spine bending unit, turn the spine
bending drive pulley [5] by a hand to move the spine bending unit.
[5]
[2]
[1]
F-2-88
[3]
[4]
F-2-89
5) Remove the reuse band [1], free the harness [2] from the four wire saddles
[3], and then pull out the connector [4].
[2]
[3]
6) With the transport roller (4/5) unit [1] moved to the left side, remove the
spine bending plate (right) [2].
- 2 scerws [3]
[1]
Chapter 2
[1]
[3]
[3]
[4]
F-2-90
[3]
[2]
F-2-91
2-21
Advertisement
Table of Contents
