Table of Contents
Advertisement
Chapter 2
2.1.31 Transport driven roller 1 (Cover transport
entrance) (15 million sheets)
1) Remove the springs [1] to remove the transport driven roller 1 [2].
NOTE:
There is a groove on the roller shaft to slide the slit of the roller shaft mount.
Remove and install the transport driven roller sliding the groove.
2.1.32 Before replacing the transport driven roller 1
(Cover transport exit) (15 million sheets)
1) Remove the rear cover. (page 2-4)Reference[Removing the Rear Cover]
2) Draw out the cover transport assembly. (page 2-5)Reference[Drawing
out the Cover Transport Assembly]
2-18
[2]
[1]
F-2-74
[1]
F-2-75
2.1.33 Transport driven roller 1 (Cover transport exit) (15
million sheets)
0024-6848
1) Remove the springs [1] to remove the transport driven roller 1 [2].
NOTE:
There is a groove on the roller shaft to slide the slit of the roller shaft mount.
Remove and install the transport driven roller sliding the groove.
2.1.34 Before replacing the transport driven roller 2
(Spine bending roller 2/3 unit) (15 million sheets)
0024-6857
1) Remove the rear cover. (page 2-4)Reference[Removing the Rear Cover]
2) Draw out the cover transport assembly. (page 2-5)Reference[Drawing
out the Cover Transport Assembly]
3) Remove the cover horizontal registration unit. (page 2-6)Reference[Re-
moving the Cover Horizontal Registration Unit]
[1]
[2]
F-2-76
[1]
F-2-77
0024-6850
0024-6849
Advertisement
Table of Contents
