Chapter 2
5) Remove the arm springs [1] and shaft spring [2], and then take out the
transport driven roller 2.
NOTE:
There is a groove on the roller shaft to slide the slit of the roller shaft mount.
Remove and install the transport driven roller sliding the groove.
2.1.36 Before replacing the transport driven roller 2
(Spine bending unit (right)) (15 million sheets)
1) Remove the rear cover. (page 2-4)Reference[Removing the Rear Cover]
2) Draw out the cover transport assembly. (page 2-5)Reference[Drawing
out the Cover Transport Assembly]
3) Remove the cover horizontal registration unit. (page 2-6)Reference[Re-
moving the Cover Horizontal Registration Unit]
2-20
[1]
[2]
F-2-83
[1]
F-2-84
2.1.37 Transport driven roller 2 (Spine bending unit
(right)) (15 million sheets)
1) Open the transport roller 2/3 unit [1].
2) Remove the harness protection cover [1].
- Screw [2]
3) Remove the two connectors [1], and then release the harness from the two
edge saddles [2].
0024-6858
[1]
F-2-85
[2]
[1]
F-2-86
[1]
[2]
F-2-87
0024-6859