Table of Contents
Advertisement
GXTRA Hardware Installation - September 11, 1997
2.7 Replacing the Workstation Cover
Replace the cover by reversing the instructions given in Sections
2.4.1 or 2.4.2. Do not hold the cover at too drastic an angle, and
slowly lower the top cover onto the chassis. Ensure that the
protector loop on the cover is properly seated in the loop slot on the
bottom of the workstation. Replace the screw(s) in the rear panel.
Figure 2.11 SPARCstation 1+ and 2 Cover Installation
2-14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
Need help?
Do you have a question about the GXTRA Series and is the answer not in the manual?