Table of Contents
Advertisement
DOK-SYTROX-MPA01******-IT02-EN-P
Rexroth Sytronix SvP 70xx Motor-Pump Unit MPA01
Power cable connection at termi‐
nal box
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
●
Lock the not needed cable introductory holes and the box itself water‐
proof and against dust.
●
Tolerance of specified tightening torque ±10%, if no others are speci‐
fied.
The following steps must be taken to connect the power cable to the terminal
box:
1.
Open the cover of the terminal box.
Unscrew and remove the mounting screws (4 pcs.).
2.
Remove the protection cover of cable gland.
3.
Detach the adapter plate ③ from the terminal box.
4.
Firmly secure the adapter plate to the metric cable gland on the power
cable. Use a reduction piece for power wire cross-sections of 1.5 mm²
and 2.5 mm².
Before attaching the power cable to the adapter plate, check the O-ring
for proper condition and correct position.
5.
Place the power cable through the opening into the terminal box up to
the adapter plate. Attach the adapter plate to the terminal box.
Tightening torque of the screws ⑥: 9 Nm.
Before attaching the adapter plate ⑥ to the terminal box, check the O-
ring ⑤ inserted in the adapter plate for proper condition and correct po‐
sition.
6.
Connect the wires according to the standard or double cabling connec‐
tion diagram.
Observe the following tightening torques:
Designation
Type
Clamp power U1,
WEF
V1, W1
Clamp 1 ... 6 tem‐
perature sensor /
WEF
holding brake (op‐
tion)
Ring terminal for
RT
PE and shield
WEF = wire end ferrule
RT = ring terminal end
Tab.8-4:
Connection screws terminal box
7.
Close and attach the terminal box lid.
Apply Loctite 243 (liquid screwlock) to the thread of the mounting
screws for the lid ① and then attach the lid with all of the mounting
screws.
Screw tightening torque: 6.5 Nm.
Before attaching the cover to the terminal box, check the glued-in seal
② on the terminal box cover for proper condition and correct position.
Bosch Rexroth AG
Connection
Size / type
mm²
1.5 ... 16 (RLK1200)
M6
1.5 ... 35 (RLK1300)
0.2 ... 2.5
Tension spring clamp
M8
59/123
Connection
Tightening torque
Nm
2.5
-
3.8
Advertisement
Table of Contents
