Table of Contents
Advertisement
DOK-SYTROX-MPA01******-IT02-EN-P
Rexroth Sytronix SvP 70xx Motor-Pump Unit MPA01
10
Commissioning
10.1
Safety
10.2
General
Prior to commissioning
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
WARNING
Live parts are dangerous.
●
Do not open any covers or flange sockets during opera‐
tion.
●
Never connect or disconnect plug connectors under
load!
WARNING
●
Do not remove any covers, machine parts or protection
devices during operation.
●
Do not enter the range of movement of the machine.
Prevent persons from entering this area, e.g., by means
of
–
–
CAUTION
●
Do not touch hot motor surfaces.
●
Install protection against contact, if necessary.
●
Make sure that no temperature-sensitive components
(cables, electronic components, ...) touch hot surfaces.
Motor-pump units can only be commissioned with other components (drive
controller, control unit). For commissioning of the motor-pump unit, two steps
are necessary:
1. Commissioning of the pump drive (motor control)
2. Commissioning the pump
Prior to commissioning, ensure that the following requirements are met.
●
Storage time of the components. Depending on the storage time, take
measures to ensure safe operation. Run in bearings, resurface the hold‐
ing brake, ... . See
chapter 6.6 "Storage Times" on page
●
Ensure that all flange socket are correctly connected and protected
against coming loose.
●
Ensure that the motor-pump unit and all participating components of the
drive are undamaged.
Bosch Rexroth AG
High electrical voltage! Danger to life, risk of
injury due to electric shock.
Risk of injury due to rotating motor shaft!
safety fence, safety guards, protective covers
Optical sensors
Thermal danger due to hot surfaces with tem‐
peratures over 70 °C during operation
69/123
Commissioning
38.
Advertisement
Table of Contents
