Table of Contents
Advertisement
DOK-SYTROX-MPA01******-IT02-EN-P
Rexroth Sytronix SvP 70xx Motor-Pump Unit MPA01
Foot fastening motor (A)
Foot fastening flange B
Flange fastening N
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Choose the fastening variant N, A or B acc. to the machine configuration.
Fig.7-9:
Assemble motor-pump-unit MPA01 into the construction.
Fastening
Foot fastening motor (A)
Foot fastening flange (B)
Flange fastening (N)
Tab.7-2:
MPA01 fastening accessorie
The figure "A" shows the assembly of motors in design "SA" (air cooling). The
figures "B," show the assembly of motors in design "FN" (liquid cooling).
The motor must be fastened with screws (4xM10) by the customer. For con‐
nection dimensions refer to the dimension sheet.
For motors with fans, detach the lower air baffles to reach the lifting points
(4x M10).
Therefore, loosen the 3 fastening screws M5x12 (crosstip) from the lower air
baffles.
Then mount the air buffles on the motor again. Tightening torque of the fas‐
tening screws for the air buffles is 6.1 Nm.
The motor must be fastened with screws (4xM16) by the customer. For con‐
nection dimensions refer to the dimension sheet.
The motor must be fastened with screws (4xM16) by the customer. For con‐
nection dimensions refer to the dimension sheet.
Bosch Rexroth AG
Hole
Screw
ø [mm]
12
M10
18
M16
18
M16
49/123
Assembly
Washer
Yes
Yes
Yes
Advertisement
Table of Contents
