Display Icons - ABB Navigator 540 Instruction Manual

Display icons

Alarm, hold and calibration icons
Alarm – indicates a user-defined alarm condition
(20-character) and flashes intermittently with an
associated NAMUR diagnostic icon.
Hold – indicates that alarms / analog outputs are in a
manual hold state.
Calibrating – indicates that a calibration is in progress.
Title bar icons
Log mode – indicates that one of the View pages is
currently displayed (Calibration, Alarm, Audit or
Diagnostic).
View mode – indicates that one of the View pages is
currently displayed (Diagnostics, Alarms, Outputs, Signals
or Chart).
Media on-line: 0 to <20 % full.
Media on-line: 20 to <40 % full.
Media on-line: 40 to <60 % full.
Media on-line: 60 to <80 % full.
Media on-line: 80 to <100 % full.
Media on-line: full (icon toggles when full)
Media off-line: 0 to <20 % full.
Media off-line: 20 to <40 % full.
Media off-line: 40 to <60 % full.
Media off-line: 60 to <80 % full.
Media off-line: 80 to <100 % full.
Media off-line: not inserted (not logging).
Media off-line: not inserted, logging active
– icon display toggles with Media off-line: not inserted (not
logging) icon.
CI/AWT540–EN Rev. C
Log icons
Source: wet-section 1 (red)
S1 T1
S1 / T1 = sensor / temperature for wet-section 1
Source wet-section 2 (green)
S2 T2
S2 / T2 = sensor / temperature for wet-section 2
Source wet-section 3 (blue)
S3 T3
S3 / T3 = sensor / temperature for wet-section 3
Source wet-section 4 (violet)
S4 T4
S4 / T4 = sensor / temperature for wet-section 4
Power failed / power failed
Configuration changed
System Error
File created / deleted
Media inserted / removed
Media on-line / off-line
Media full
Date / time or daylight saving start / end changed
High process alarm active / inactive
Low process alarm – active / inactive
High latch alarm – active / inactive
Low latch alarm – active / inactive
Alarm acknowledged
Status bar icons
Operator menu – displays the Operator menu when the
key is pressed.
Autoscroll – selected from the Operator menu (displayed
when Autoscroll enabled). Indicates Operator pages are
displayed sequentially. Disabled if 1 Operator page only is
configured for display.
Calibration – shortcut access to the Calibration page when
the key is pressed.
Enter – selects the highlighted option from the Operator
menus when the
Service Level – indicates that alarms and analog outputs
are held.
Advanced Level – indicates that Advanced Level
parameters are enabled for the current user.
Calibrate Level – indicates that the Calibration Level
parameters are enabled for the current user.
Read Only Level – indicates that the transmitter is in Read
Only mode. All parameters are locked and in cannot be
configured.
key is pressed.
15