Connector Information - Dynojet Power Commander III Installation Instructions

Stock connectors
Ground wire from PCIII
i910-411 www.powercommander.com
Unplug this connector
PCIII connectors
Ground bolt
7 Locate the grey 3 pin connector
under the right hand side cover
(Fig. D). Unplug this connector.
8 Route the white connectors from
the PCIII between the front
fender and the frame to this con-
nector.
.
9 Plug the connectors from the
PCIII in-line of the stock harness
(Fig. E).
10 Locate the common ground near
the ECU. Remove the bolt and
feed through the terminal of the
black wire of the PCIII and the
stock terminals. Tighten bolt
(Fig. F).
2004 Polaris Sportsman 700 PCIII USB - 3