Roof Assembly - Alton Evolution octagonal Instruction Manual

Roof Assembly

To begin constructing the roof you will first need the top bracket
(EV1003M) and two roof bars (EV0966).
Working on the floor, slot the bracket onto the first roof bar. Drill
pilot holes through the pre-drilled holes in the bracket. Then fix in
place with 35mm countersunk screws (diagram 41).
Add the next glazing bar in the opposite position to the last bar
and fix this in place (diagram 42).
Internal
35mm Screw
EV1003M Diagram 42
35mm Screw
Diagram 41
This assembly can then be offered up to the main
building assembly, each end of the roof bar will
Internal
slot into the cast eaves bracket at the top of the
side glazing bars (diagram 43).
Diagram 43
8
22