Alton Evolution octagonal Instruction Manual page 10

Side Assembly
Left of Door
Dia. 15
Diagram 14
Now build the assembly to the
left of the door, take the last
eaves bar with the cast eaves
X 1
brackets attached and fix a
standard side glazing bar in
the left hand eaves bracket.
Now use the glazing bar with a
External
wedge shape on the right side
(EV0971) and fix that to the
right hand eaves bracket
(diagram 15). Again drill pilot
holes and fix using 50mm
screws. Remember not to over
tighten these screws as it may
make it difficult to glaze later in
the build.
Now insert the mid rail. This is
also shaped to go next to the
door (Diagram 17). Drill a pilot
hole through the side of the
glazing bars and fix with an
Diagram 15
80mm screw (diagram 16 & 17).
Again, just slot the cill section
(EV0950) into place without
Dia. 17
Dia. 16
any fixings (diagram 9).
External
Diagram 17 Internal
Diagram 16
4
10