1 4 - 5 A d j u s t i n g t h e s p r e a d e r s
The clearance between spreader K,L and M and needles should be 1~1.2mm.
Spreader up-and-down adjustment is made with screws Q.
Spreader tilt adjustment is made with screws R.
【15】PTV MECHANISM
1 5 - 1 D i s a s s e m b l i n g a n d r e a s s e m b l i n g t h e b i n d e r
■ T o disassemble the binder
Remove screw A. Remove the binder by pulling it
toward you while referring to arrows B and C.
< Note >
When removing the binder, be careful not to damage the
ends of the fabric guides.
■ T o reassemble the binder
Fit the ends of upper fabric guides (F) onto lower
fabric guides (G). Move the binder down in the
direction of arrow H.
screw touches the bracket. Then tighten screw A.
Check that end D of the
30