Uncritical Surfaces Including Monitor - Dentsply Sirona CEREC Omnicam AC Operating Instructions Manual

6 Maintenance
6.1 Cleaning, disinfection and sterilization
64
6.1.2

Uncritical surfaces including monitor

NOTE
Do not allow liquids to penetrate into the ventilation slots!
NOTE
Never use corrosive cleaning agents, wax or solvents.
CAUTION
Risk of infection
There is a risk of infection if surfaces are not regularly disinfected.
➢ Following each treatment, wipe disinfect the following non-critical
contact surfaces:
- the scanner holder,
- the operator console,
- the monitor (including handles on the rear of the monitor)
- the handle (front and rear).
1. Use a new absorbent cotton gauze which is moistened with one of
the cleaning agents listed in the "Wipe disinfectants (virucidal
limited)" section or a moistened cloth to disinfect the non-critical
contact surfaces.
2. To clean and disinfect the monitor, follow the following steps, so
that the monitor is frozen and you are not able to accidently activate
a function on the screen during wiping:
a) Press simultaneously on the left and right button on the
touchpad / trackball for approx. 1 second. The screen turns dark
and "device locked" appears.
b) Wipe the monitor.
c) Unlock the monitor with the foot control.
3. Then remove the absorbent cotton gauze or wiping cloth.
Please ensure that no colored cloths are used for this as these can
result in discoloration of the surfaces, e.g. when used in combination
with disinfectants.
Protection against medicaments
Due to their high concentrations and the substances they contain, many
medicaments can dissolve, etch, bleach or discolor surfaces.
NOTE
The only way to prevent damage is to wipe off medicaments
immediately with a damp cloth and a cleaning agent!
Dentsply Sirona
67 15 499 D3696
D3696.201.02.04.02 09.2019