Connecting The Imatch Interface (Option); Connecting The Imatch Interface To Your Network - Kalfire G Series Installation Instructions Manual

Fig. 22: Connector for external devices
Examples of AUX devices and OPEN contacts are:
'AUX' devices (AUX enable):
•
fan to improve convection air outflow.
•
safety valve control in gas supply
•
illumination of indicator lights
•
powered up electrical devices (for example: indirect
lighting).
'OPEN' contacts (Open enable)
•
switched off / deactivated electrical devices (e.g. lighting,
heating etc.).
Schematic overview:
Connection Fire switched on Fire switched off MAX
Open enable Open contact
AUX enable Closed contact

5.11 Connecting the iMatch interface (option)

The iMatch interface consists of three components.
B1
Fig. 23: iMatch interface
22
Closed contact 250 VAC / 5A
Open contact 250 VAC / 5A
B2
Connect the cables as indicated in the visual.
1. Install the iMatch interface in the technical unit.
2. Connect cable A to the burner control (HDIMS)
and the iMatch interface. See: the wiring diagram on
page 86.
3. Disconnect the adaptor cable (24 V) from the automatic
burner relay (HDIMS) and connect it to cable B.
4. Connect cable B1 to the automatic burner relay (HDIMS).
5. Connect cable B2 to the iMatch interface.
6. Check if the red LED indicator lights up on the iMatch
interface and if the lamp on the HDIMS is flashing.

5.11.1 Connecting the iMatch interface to your network

First connect the iMatch interface before connecting to your
network. The red LED lighting will flash slowly if the iMatch
interface is correctly connected. The LED lighting will be on
continuously after it has been switched on.
Fig. 24: iMatch interface LEDs
If the red LED lighting is continuously alight, you can configure
the iMatch connection. See: Configure the iMatch app on page 26.
After configuration you can operate the appliance with the
iMatch app,
the green LED will be on and visible in the iMatch interface.
If the red and green LED lights are flashing, you can carry out the
following steps to reconnect;
1. Place the iMatch interface and the Wi-Fi point closer to one
another to reduce the distance (if necessary).
2. Erase the corresponding room from the iMatch app (if this
is configured).
3. Carry out the reset procedure.
See: Resetting the iMatch interface on page 26.
Fig. 25: iMatch interface reset