Error Codes Imatch Remote Control - Kalfire G80/48F User Instructions

5.2.2 Error codes iMatch remote control

Error code Cause
Entire
display
Flat battery
flashing
Low battery
NOLK 0 in
the middle Bedienings-
of the fout
display
No com-
munication
between
remote
NOLK
control and
top left
fireplace
display
(for example
in case of a
new remote
control)
24
Solution
Replacing battery.
Replacing battery.
Druk kort op >NOLK< zal nu linksboven in het display
verschijnen.
Synchronising remote control:
1. Open the hatch of the technical unit and carefully
remove the automatic burner relay so it is easily
accessible.
2.
Remove the batteries from the remote control and
press (hereby discharging the remote control). Next,
replace the batteries into the remote control.
3.
Isolate the automatic burner relay from power for
20 seconds, this will stimulate the synchronisation
speed. Supply power back to the cable. The entire
light will start flashing (once per second). Should
the gas fire is provided with a hybrid function and/
or NSG: detach the HCB cable from the automatic
burner relay.
4.
Press on the remote control until
appears on the display.
Next, release
5. >NOLK 1<
In case
>NOLK 0<
again until
6.
Press the black button in the automatic burner relay
until the yellow light continuously stops flashing, then
immediately release the black button. The yellow light
will start flashing rapidly now.
7.
Immediately (within 10 seconds) press
it down until the word
display.
8. >LINK 1<
Wait until
9.
Press . The normal display with a stationary RF
icon will appear once the synchronisation is
successful.
10.
Reconnect the HCB cable (if applicable).
11.
Place the automatic burner relay back into the
technical unit and close the hatch.
.
>LINK 1<
or appear, press
appears.
>LINK<
starts flashing on the
appears and release
>NOLK 0<
and hold
.