Adjusting The Stone Support; Continuous Rear Wall Finishing (Option); Connecting The Gas Fire - Kalfire G Series Installation Instructions Manual

5.2.2 Adjusting the stone support

The gas fire is equipped with stone support, so tiles or other
plateau-finishing materials can be supported to the side of the
fireplace.
The stone support can be adjusted without using steps over a 30
mm distance. The stone support is equipped with an indicator
for a stone thickness of 20 mm to 30 mm, as depicted. The stone
support can also be removed as one.
Fig. 8: Stone thickness indicator
Fig. 9: Glass support (corner and three-sided appliances only)
Carry out the following steps to adjust the stone support;
CAREFUL! While adjusting the stone support, the glass
support to the left and right of the appliance cannot be
removed.
1. Unscrew the nuts at the bottom end of the assembly strip.
2. Set the desired height.
3. Tighten the screws and place the stones.
4. Leave a minimum of 4 mm between the stone and the glass.
See Installation Instructions on page 8.
5. At the front, leave a minimum of 1 mm of space between the
glass support and the finishing. Prevent excessive tension
on the glass caused by the glass support as a result of heat
expansion.
16
1 mm

5.2.3 Continuous rear wall finishing (option)

When opted for a continuous real wall finishing, the following
steps should be carried out:
1. Determine the side to which the rear wall is to be continued.
2. Remove the four nuts as depicted in the figure.
Fig. 10: Removing the strip
3. Unscrew the upper and lower nuts.
4. Remove the steel vertical strip.
5. Place the panel (ceramic glass or design) that you wish to
continue outside of the fireplace in the correct position.
6. Always leave 4 mm space between the panel and the
glass frame, in order to keep it accessible for service
requirements.
Fig. 11: Space between panel and fireplace (4 mm)

5.2.4 Connecting the gas fire

This task describes how to connect the technical unit and the gas
fire.
CAREFUL! Do not directly expose the technical unit to
heat. See Installation Instructions on page 8 .
REMARK: Use the wiring diagram when connecting. See
Wiring diagram on page 86.
1. Connect the flexible gas hose to the side of the gas fire.
2. Check the connection for gas leakage.
3. Assemble the 24V power supply cable.
4. Connect the white plug to the ionisation cable.
5. Place the ionisation cable (covered by the black surround at
the end).