Installation; General Requirements - Pilz PSS Series Operating Manual

Installation

General requirements

Please note the following:
• The safety system should be installed in an enclosure, e.g. control
cabinet, that conforms to the protection class required for the
environment.
• When installing the system in an enclosure such as a control cabinet, the
environmental data for the safety system must be taken into account.
Details can be found in the chapter entitled "Technical Details".
• Ensure there is sufficient ventilation to prevent heat building up within the
control cabinet. Please note the ambient temperature of 0 ... 60 °C.
• In extreme ambient conditions, additional measures may be required in
order to keep within the prescribed value range.
• Use low interference panel lighting for inside the control cabinet.
• The safety system must be installed in such a way that there is adequate
protection against buttons and switches being operated unintentionally.
CAUTION!
Damage due to electrostatic discharge!
Electrostatic discharge can damage components on the safety system.
Ensure against discharge before touching the PSS, e.g. by touching an
earthed, conductive surface or by wearing an earthed armband.
Operating Manual: PSS SB 3006-3 Series
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
5-1