Automatic Accumulation; Parameters - Adam Equipment CBW Series Manual

6.9

AUTOMATIC ACCUMULATION

• When the scale has been set to Automatic Accumulation the
value is stored in memory automatically.
• Add a weight to the scale. The beeper will sound when the scale
is stable indicating the value is accepted. Remove the weight.
• The display will show "ACC 1" and then the total in the memory
before it returns to zero.
process.
• While the weight is on the scale, press the [Print] key to show the
values immediately- first the accumulation number "ACC x" and
then the total will be shown. In this case the scale will not show
the value when the weight is removed.
• In all cases the scale must return to zero or a negative number
before another sample can be added to the memory.
• More products can be added and [Print] be pressed again. This
can continue for up to 99 entries till the capacity of display is
exceeded.
7.0

PARAMETERS

The parameters can be chosen by the user to set the scale to:
• Display the weight in other increments of weight to minimise the
affects of vibration, wind or other environmental conditions.
• Control the back light on the display. It may be necessary to turn
the backlight off to maximise battery life.
• Set the Accumulation to Automatic, manual or set the RS-232
interface to continuously print the weight.
• Enable the accumulation when [Print] is pressed or to disable.
• Set a range for auto zero.
• Select another weighing unit than the standard.
• Set the check weighing alarm.
• Set the speed.
© Adam Equipment Company 2006
nd
Adding a 2
14
weight will repeat the