Counting More Parts; Automatic Part Weight Updates; Count Preset Or Check-Weighing - Adam Equipment CBC 3 Manual

6.3.2 Counting more parts

• After the unit weight has been determined or entered, it is
possible to use the scale for parts counting. The scale can be
tared to account for the container weight as discussed in the
earlier section.
• After the scale is tared the items to be counted are added and the
"Count" display will show the number of items, computed using
the total weight and the unit weight.
• It is possible to increase the accuracy of the unit weight at any
time during the counting process by entering the count displayed
and then pressing the [Smpl] key. You must be certain that the
quantity displayed matches the quantity on the scale before
pressing the key. The unit weight can be adjusted based upon a
larger sample quantity. This will give greater accuracy when
counting larger sample sizes.

6.3.3 Automatic part weight updates

• The scales will automatically update the unit weight when a
sample less than the sample already on the platform is added. A
beep will be heard when the value is updated. It is wise to check
the quantity is correct when the unit weight has been updated
automatically.
• This feature is turned off as soon as the number of items added
exceeds the count used as a sample.

6.3.4 Count preset or Check-weighing

• Check-weighing (Count Pre-setting) is a procedure to cause an
alarm to sound when the number of items counted on the scale
meets or exceeds a number stored in the memory by using the
[Pst] key.
• The stored value is entered from the keyboard. Enter the numeric
value to be stored using the numeric keys. Then press the [Pst]
key to store the value.
• To clear the value from the memory and thereby turn off the
check-weighing feature, enter the value "0" and press [Pst].
© Adam Equipment Company 2006 14