Setting Up Checkweighing While Parts Counting; Accumulated Total - Adam Equipment CBW Series Manual

6.6.2 Setting up Checkweighing while Parts Counting

• Checkweighing facility can be set up for Parts Counting by
entering values as Low and High Limits to be keyed in by the
user. The limits are displayed in PCS.
• Press [Func] to enter the Parts Counting mode. Press
[Zero/Enter] to fix a sample size. Press [Limit] and enter the
numeric values for high and low limits following the same
procedure as stated in the earlier section.
NOTE:
• The weight must be greater than 20 scale divisions for the check-
weighing to operate.
• To disable the Checkweighing function, enter zero into both limits
by pressing [Limit/
• When the current limits are shown, press [Func/C] to clear the
settings and then press [Zero/Enter] to store the zero values.
6.7

ACCUMULATED TOTAL

• The scale can be set to accumulate when a weight is added to the
scale automatically or manually by pressing [Print].
• See Section 7.3 on PARAMETERS for details. The accumulation
function is only available when weighing. It is disabled during
percent weighing or parts counting.
• The accumulated weights will be stored in the master unit of the
scale, i.e. kg or lbs.
• If at any time the weighing units are changed, the accumulated
data will be lost.
© Adam Equipment Company 2006
] to recall the current settings.
12