List Of G Functions/Preparatory Functions - Siemens SINUMERIK 840Di sl Programming Manual

OEM addresses
OMA1: OEM OEM
address 1 ) address 1
2
OMA2: OEM OEM
address 2 ) address 2
2
OMA3: OEM OEM
address 3 ) address 3
2
OMA4: OEM OEM
address 4 ) address 4
2
OMA5: OEM OEM
address 5 ) address 5
2
*) Absolute end points: modal, incremental end points: non-modal, otherwise modal/non-
modal depending on syntax of G function.
**)As circle center points, IPO parameters act incrementally. They can be programmed in
absolute mode with AC. The address modification is ignored when the parameters have
other meanings (e.g., thread pitch).
) The vocabulary word is not valid for SINUMERIK FM-NC/810D.
1
) The vocabulary word is not valid for SINUMERIK FM-NC/810D/NCU571.
2
12.3

List of G functions/preparatory functions

List of G functions/preparatory functions
In the list of G functions/motion commands you will find all available G codes according to
the appropriate functional groups.
Legend for describing the G groups
No.: internal number for, e.g., PLC interface
X: No. for GCODE_RESET_VALUES not permitted
m: modal or n: non-modal
Def.: Siemens AG (SAG) default setting, M: Milling: T: Turning or other conventions
MM.: Default setting, please see machine manufacturer's instructions
Group 1: Modally valid motion commands
Name No. Meaning
G0 1. Rapid traverse
G1 2. Linear interpolation (linear interpolation)
G2 3. Circular interpolation clockwise
G3 4. Circular interpolation counter-clockwise
CIP 5. Circle through points: Circular interpolation through intermediate point
ASPLINE 6. Akima spline
BSPLINE 7. B-spline
CSPLINE 8. Cubic spline
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
m
m
m
m
m
12.3 List of G functions/preparatory functions
x x x
x x x
x x x
x x x
x x x
Tables
1 Real
1 Real
1 Real
1 Real
1 Real
X m/n SAG MM
m
m Def.
m
m
m
m
m
m
479