Turning:
Deactivate programmable zero offset:
For all axes: TRANS (without axis parameter)
Programming
TRANS X... Y... Z... (substituting instruction programmed in a separate NC block)
Or
ATRANS X... Y... Z... (additive instruction programmed in a separate NC block)
Parameters
TRANS
ATRANS
X Y Z
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Absolute zero offset, with reference to the currently valid workpiece zero
set with G54 to G599
as TRANS, but with additive zero offset
Offset value in the direction of the specified geometry axis
Frames
6.3 Programmable zero offset
233